Delta Q Leveling Procedure

Delta Q Leveling Procedure

Delta Q Sterilizer


Delta Q Sterilizer Leveling Procedure WARNING: Counter top must be wide enough to support all unit feet. All unit feet must be securely placed on counter top

The Delta Q has been pre-leveled during manufacturing therefore “NO” leveling is required. However, if the unit is placed on a surface that is not level then follow the leveling instructions below:

  • Remove all trays from the chamber
  • Pour distilled water into chamber
  • Adjust leveling feet (C) until water comes to the pull tab of the inline filter assembly (A) (located in the rear of chamber) and reaches the top of water dam (B) at the front of chamber.
  • Reinstall trays and tray rest
  • Close door and run one cycle on the unwrapped cycle according to the operating instructions


  • This product was added to our catalog on Thursday 07 January, 2010.



Sponsors

Testimonials

If I ever need any autoclave repairs, or parts, or even a new au

If I ever need any autoclave repairs, or parts, or even a new au

Dear Wally: This message is not only for you,Wally, but especially for all the people who have autoclave problems. I hope they read this. As a...
Read More ->


I will gladly recommend you to all of my colleagues

I will gladly recommend you to all of my colleagues

Wally, Thank you and your company for providing great customer service and all the help I needed to fix my autoclave. It took only few minutes, but...
Read More ->


Call Wally at AllClaveParts.com first before your local repairma

My Tuttnauer 2540M autoclave quit building up pressure. A new gasket did not solve the problem. The dental repairman said that three of the four...
Read More ->


Great service from the AllClaveParts company

Great service from the AllClaveParts company

Great service from the AllClaveParts company. I have saved over a thousand dollars repairing my own Statim unit with their guidance. I strongly...
Read More ->


I will recommend your site to all my dental friends

I will recommend your site to all my dental friends

My Statim 2000 stopped working. Benco dental came down and said the thermal fuse and computer board was bad. Cost $2600 to repair with 90 day...
Read More ->


Have you seen ...

Parse Time: 0.283 - Number of Queries: 152 - Query Time: 0.0988704946289
Content

Custom Left Slide Out

You can add any content here, text, images, etc.



your alt text here