EZ9 FAN (AXIAL)

• 3.15" square x 1" wide
• 0.15A @ 12VDC
• Airflow: 32 CFM
• Dual ball bearings
• 2500 RPM
• Includes connector

The Tuttnauer EZ9 Fan Is Located behind the Control Panel (inside the cabinet) laying flat on the base of the autoclave, as shown in the picture above

Note: The Fan is for keeping the circuit boards cool, not for drying the instruments

Replacing The Tuttnauer EZ9 Fan Is Not Difficult, Nor Does It Require Any Special Tools (Just a Screwdriver). To Replace The Fan, Follow These Easy Step-By-Step Directions:

1. Unplug the autoclave
2. Remove the Outer Cabinet
3. Disconnect the flat ribbon cable and the green ground wire going to the Front Console Panel
4. Remove the Front Console Panel (one screw on top, one screw on the bottom)
5. Disconnect all connectors going to the Electronic Box
6. Remove the Electronic Box (one screw on top, two screws on the bottom)
7. Disconnect the Fan from JP5 or JP10 or JP15 depending on the model autoclave
8. From the bottom of the Electronic Box remove the four screws holding the Fan
9. Replace the Fan
10. Repeat the previous steps in the reverse order to reassemble the unit