Add to Cart:

  • Description
  • Info & Guide
  • Specs
  • Reviews
Guaranteed Quality

Part #MIS075-815
Midmark Part #002-0358-00


  • Sensor Disk
  • Spacer
  • Teflon Tube
  • Compression Nut with Ferrule
  • Terminal Nut
  • Terminal
Fits: Chamber

Model This Part Fits: Midmark M11 Autoclaves

Here is where to Find The Water Level Sensor
Inside The Midmark M11 Autoclave Chamber
Looking Inside The Midmark M11 Chamber
Click on Image For Larger Picture

Click Here To Learn How To Test The Midmark M11 Water Level Sensor

How To Replace
The Midmark M11 Water Level Sensor Assembly

Removing The Old Midmark Water Level Sensor Assembly

  1. Disconnect wire from Sensor by pulling if off of the Terminal
  2. Using a wrench, remove Terminal Nut, Terminal & Compression Nut
  3. From inside the chamber, remove Sensor, Spacer & Teflon Tube
Midmark Water Level Sensor Assembly

Installing The New Midmark Water Level Sensor Assembly

  1. Install Teflon Tube & Spacer onto Sensor.
    Install Sensor thru hole in chamber
  2. Install Compression Nut and then install Terminal & Terminal Nut
    Caution: DO NOT Over-Tighten Compression Nut (Tighten 1¼ turns past finger-tight)
  3. Perform continuity test to make sure assembly is not grounded (it should not be continuous)
  4. Connect Sensor wire to Terminal

There are currently no any reviews about this product.

Customers who bought this product also purchased...

Customer Reviews
Solution Graphics
Pay By Credit Or Debt Card
-Pay By Credit Card-
Proceed To Checkout And Enter Your Credit Card Information In Step 2

Pay By Credit Or Debit Card
To Order By Phone Call
Mon thru Fri 8:00am To 4:30 pm Central Time


Don't Take Our Word For It.....

Customer Reviews

AllClaveParts.com - Real Help With Your Autoclave Repair When You Need It

"My Statim 2000 stopped working.

Benco dental came down and said the thermal fuse and computer board was bad

Real Problems Solved By Dr Gorenburg With AllClaveParts help

Wally, thank you and your company for providing great customer service and all the help I needed to fix my autoclave.
Clearview Medical.com

Dr Haruki & Son

My tech told me my STATIM 2000 repair could either be about $350 (if it was only the thermal fuse) or up to $1500 if it was another problem.

Craig Haruki DDS
Lihue, HI

Dr Whitehouse Loves AllClaveParts.com
"It was a pleasure working with Wally who saved me thousands over what I would have had to pay when the Patterson tech......"

Dr Joseph Whitehouse
Castro Valley, CA
Create A Smile

Dr Steve Says Midmark Told Him To Throw It Away, But AllClaveParts Showed Him How To Fix It Well, that same autoclave is once again working like a champ thanks to allclaveparts.com.

Steve Douglas, DDS
Indianapolis, IN

Parse Time: 0.346 - Number of Queries: 359 - Query Time: 0.172566052689

Check Out Our Specials

A Best Seller
Click Here To Check Out Everything On Sale