Shopper Award


Model: MIS075-7373


Guaranteed High Quality Midmark M9D Autoclave Repair Parts

M9D Water Level Sensor Asssembly

Midmark Part #002-0358-00

The Water Level Sensor Tells The Autoclave's PC Board When There Is Enough Water In The Chamber To Start The Cycle

Assembly Includes
  • Sensor Disk
  • Spacer
  • Teflon Tube
  • Compression Nut with Ferrule
  • Terminal Nut
  • Terminal
Fits: Chamber

Model This Part Fits: Midmark M9D Autoclaves

Here is where to Find The Water Level Sensor

The Water Level Sensor is Located Inside The Midmark M9D Autoclave Chamber
Looking Inside The Midmark M9D Chamber
Click on Image For Larger Picture

How To Replace The Midmark M9D Autoclave Water Level Sensor Assembly

Start By Removing The Old Autoclave Water Level Sensor Assembly:
  1. Disconnect wire from Sensor by pulling if off of the Terminal
  2. Using a wrench, remove Terminal Nut, Terminal & Compression Nut
  3. From inside the chamber, remove Sensor, Spacer & Teflon Tube
Midmark Water Level Sensor Assembly
Next Install The New Midmark M9D Autoclave Water Level Sensor Assembly:

  1. Install Teflon Tube & Spacer onto Sensor
  2. Install Sensor thru hole in chamber
  3. Install Compression Nut and then install Terminal & Terminal Nut
    Caution: DO NOT Over-Tighten Compression Nut (Tighten Only 1¼ turns past finger-tight)
  4. Perform continuity test to make sure assembly is not grounded (it should not be continuous)
  5. Connect Sensor wire to Terminal
Open the Door and Look Inside

"Midmark M9D Autoclave Repair Made Simple"

There are currently no any reviews about this product.

There is no any question about this product.


Fast Delivery
We usually ship the same day! All packages are shipped w/ Delivery Confirmation

100% Secure Payment
Your transaction is secure thanks to the paypal payment system: SSL (Secure Socket Layer)

Shopper Award

AllClaveParts Payment Methods

Customers who bought this product also purchased...