Shopper Award
AllClaveParts
MAGNACLAVE HEATER STRIP (WALL) (208V)

MAGNACLAVE HEATER STRIP (WALL) (208V)

(0)
Model: PCH089-281

$208.97
All of the Pelton Crane Magnaclave Replacement Parts We Offer Are Fully Guaranteed

Part #PCH089-281
Pelton Crane Part #004516

WALL HEATER STRIP (208V)
  • 500W
  • 208VAC
  • ~87 ohms
Includes
  • Terminal Hardware
Fits: Chamber

Model This Part Fits: All Pelton Crane Magnaclaves

Also Available

How To Test Pelton Crane Magnaclave Wall Heater Strip


This test consists of measuring the amount of resistance in the element. To do this, first, turn the autoclave off and unplug it from the wall

WARNING: CURRENT MUST NOT BE PRESENT WHEN MEASURING RESISTANCE

Set your volt/ohm meter on 200 ohms (200 NOT 200k). The ohms range is located within the Omega (Ω )(look for this symbol) section of your meter. It is also the area with "k" ranges (ie: 2000k,. 200k, 20K and then 2000, 200).

Place a probe from the volt/ohm meter on each wire where it connects to the element (it really doesn't matter which color probe goes where) and check your reading

For the heating element to be good, it must fall within the resistance range in this table (between 103.5 and 126.5 ohms) If your reading is outside of this range, then it is defective and needs to be replaced.
Model Volts Watts Amps Resistance Resistance Range
Magnaclave Wall Heater Strip
208V vac 500 2.4039 amps ~87 Ohms 78.3 ↔ 95.7 ohms

How To Replace The Magnaclave Wall Heater Strip

  1. Remove the old heater in normal fashion
  2. Inspect and clean outside of chamber
  3. Install new heaters, making sure that contact between heater and chamber is evenly distributed. CAUTION: To assure no burnouts due to hot spots:
    • Chamber surface is dry and smooth
    • Contact of heater to chamber is completely even and uniform
  4. Sequentially tighten tie down bands. The same amount of torque should be applied to all four bands (40 in. lbs.)
  5. Perform final inspection. Verify that the curvature of the heaters matches the chamber and no gaps exist. Allow 10-15 minutes "burn-in" time.
Warning: Excessive tightening of nuts may cause heater to fail


There are currently no any reviews about this product.

There is no any question about this product.

Qty

Fast Delivery
We usually ship the same day! All packages are shipped w/ Delivery Confirmation

100% Secure Payment
Your transaction is secure thanks to the paypal payment system: SSL (Secure Socket Layer)

Shopper Award

AllClaveParts Payment Methods

Customers who bought this product also purchased...