OCR SOLID STATE CONTROLLER (BOARD) WITH WIRING HARNESS



$284.97

Add to Cart:


  • Description
  • Info & Guide
  • Specs
Guaranteed High Quality Pelton Crane OCR Autoclave Repair Parts

Part #PCT007-132
Pelton Crane Part #019110 (Board only)

SOLID STATE CONTROLLER WITH WIRING HARNESS


Includes Note: Trim Pot (Temperature Controller) Part #PCC112-090 may have to be adjusted

Fits: Mounts on bottom plate of Autoclave

Note: Before Ordering. trace the 2 black wires leading from your thermistor (located on the chamber) to the Solid State Controller you currently have. If they are soldered ("hard wired") to your exisitng board (that is, they do not plug into the board) you will need to order the Thermistor Connector Kit Part #PCC062-088.

Installation Instructions Included

"How To Test The Pelton Crane OCR Solid State Controller"



Before Testing The solid state Controller, Test each of the following components for continuity If any of these OCR components are not continuous, they must be replaced and could very well be the source of the problem you are experiencing

For a basic test of the OCR Solid State Controller, measure the voltage from the top terminal of the Power Switch To The Common Terminal Of The Function Switch

If your reading is approximately 120 volts, the board is open and will need to be replaced.
If your reading is 0 VAC, the board is probably good.

This is provided there is continuity through the function switch, over heat thermostat and the heating elements as outlined above

Model This Part Fits: Pelton Crane OCR Autoclaves



Customer Reviews
Solution Graphics
Pay By Credit Or Debt Card
-Pay By Credit Card-
Proceed To Checkout And Enter Your Credit Card Information In Step 2

Pay By Credit Or Debit Card
To Order By Phone Call
636-390-2792
Mon thru Fri 8:00am To 4:30 pm Central Time

Testimonials

Don't Take Our Word For It.....


Customer Reviews


AllClaveParts.com - Real Help With Your Autoclave Repair When You Need It

"My Statim 2000 stopped working.

Benco dental came down and said the thermal fuse and computer board was bad

Real Problems Solved By Dr Gorenburg With AllClaveParts help

Wally, thank you and your company for providing great customer service and all the help I needed to fix my autoclave.
Clearview Medical.com

Dr Haruki & Son

My tech told me my STATIM 2000 repair could either be about $350 (if it was only the thermal fuse) or up to $1500 if it was another problem.

Craig Haruki DDS
Lihue, HI


Dr Whitehouse Loves AllClaveParts.com
"It was a pleasure working with Wally who saved me thousands over what I would have had to pay when the Patterson tech......"

Dr Joseph Whitehouse
Castro Valley, CA
Create A Smile


Dr Steve Says Midmark Told Him To Throw It Away, But AllClaveParts Showed Him How To Fix It Well, that same autoclave is once again working like a champ thanks to allclaveparts.com.

Steve Douglas, DDS
Indianapolis, IN
stevedouglasddspc.com


Parse Time: 0.273 - Number of Queries: 229 - Query Time: 0.125890428711
Content

Check Out Our Specials


A Best Seller
Click Here To Check Out Everything On Sale