OEM Part #1539241 (Gasket only)
STERILIZER PM KIT
- Includes: See Notes
- All parts are also sold separately
- For annual PM of sterilizer or as needed
Model(s) This Part Fits: Validator Plus 8, Delta 8" (AE)
Preventative Maintenance Checklist
& Installation Instructions
Sterilizer PM Kit (Part #PCK222-171)
Delta 8" (AE) Sterilizer Preventative Maintenance Kit
||Sterilizer Preventative Maintenance Tip
|PART # PCG065-223
||Remove the old door gasket. Clean the gasket groove and chamber face ring surface.
For easy install of the new gasket, use the "star" or "North-South-East-West" method (ie. begin
installing the gasket at the top of the door, then the bottom, then the left side, then the right side,
and then eveything in between making sure that the gasket fits flush without bumps or gaps).
|PART # PCS067-233
||Take CAUTION when removing or installing the door spacer: the doors tabs can be sharp.
To install door spacer, place the spacer on and over the door tabs. The spacer MUST lie flat against the door.
|PART # PCF009-220
||Filter Fill Line (Chamber)
|| Remove all trays from the chamber. Remove the chamber filter. Clean chamber.
Install new filter making sure that the it is placed at the bottom and center of the chamber.
|PART # PCK167-224
||Reservoir Filter Kit
||Remove the sterilizer cover, drain and clean the reservoir if necessary when removing
the old reservoir filter.
Be sure to install the new o-ring when installing the new filter. Refill with
distilled water only.
||Delta AE Sterilizer
||After replacing the PM parts:
- Conduct a temperature check using a
Max Register Thermometer (Part #RPT113)
- Conduct a pressure check to identify any leaks that may
need to be addressed.