Installing the Stryker 840 Cast Cutter Blade Collar

The Blade Collar is used to lock the Saw Blade in place, making it so the blade turns as the shaft turns

How To Replace The Stryker 840 Cast Cutter Collar



Replacing the Collar is easy. The only tool you will need is a standard 1/2 inch wrench to complete the repair

Removing The Old Collar

  1. Using the 1/2 inch wrench, remove the Shaft Nut Part #STN017-6127
  2. Then remove the Shakeproof Washer Part #STW025-6132
  3. The remove the old Blade Collar
Easy installation of the Stryker 840 Blade Collar


Now it is time to put it all back together

How To Install The New Collar

If you removed the saw blade, you will need to install it before proceeding. Place the blade on the shaft as far as it will go with slots in blade aligned with pin(s) in shaft

  1. Place the New Collar over the Shaft Part #STS023-6130, with slotted side facing blade and slots aligned with pin on shaft....locking the blade in place
  2. Now slide the Shakeproof Washer Part #STW025-6132 until it is resting against the collar
  3. Thread on nut and tighten securely. Be certain blade and collar remain aligned on pin while tightening
You can get all of these parts plus a New Blade with our New Stryker 840 Cast Cutter Blade & Collar Kit Part #STB015K-8193

allclaveparts.com widget logo