SECTION 1- GENERAL SERVICE INFO
I. Removing & Replacing The Cover
To unfasten the cover, remove only the two screws (A) at bottom of the rear panel.
Remove reservoir fill cup (B). Slide Cover (C) to rear. Lift front of cover slightly to clear top of reservoir.
When replacing cover, make sure lip of front panel engages in slot along all ledges. Re-install screws and reservoir cup.
II. Draining Reservoir
Caution: Empty reservoir before turning unit over for service and before shipping.
With the door open, locate the quick drain connector (D) at the lower right corner of the face plate. Press the drain tube connector provided with the unit into the connection on the face plate. This opens the drain line and draining the reservoir will begin immediately.
III. Printed Circuit Boards
Printed Circuit Boards used in the Validator Plus are static sensitive. Damage may occur if printed circuit boards are not handled carefully. Before handling any board, touch a grounded surface to eliminate static charge.
There are no user adjustments on the printed circuit boards. All calibrations must be made using special test fixtures at the factory. Unauthorized adjustments are not covered by the warranty
Use static protection bags when storing, shipping or returning boards.
IV. Spore Test
To verify satisfactory sterilization, place a biological spore test indicatot (Attest Biological Monitoring System, 3M, St Paul, MN; Propper, Long Island, NY) inside a representative load after any repair.
V. Leveling Feet
Adjustable feet (E) are provided on the front of the Validator Plus to compensate for uneven countertops. The unit must be reasonably level to ensure proper draining and water distribution inside the chamber. (Leveling feet are hand adjustable).
Categories
- Autoclave Maintenance0
- Autoclave Parts6269
- Bulk Sterilizers2277
- AMSCO/STERIS1949
- AMSCO Medallion Sterilizer247
- AMSCO/Steris Parts Instructions2
- Amscomatic Washer / Sterilizer20
- Century Bulk Sterilizers83
- Eagle 2000797
- Eagle 3000800
- CASTLE/GETINGE252
- STERIS63
- STERRAD1
- Other Bulk Sterilizers12
- AMSCO/STERIS1949
- Autoclave Cleaning Products11
- AMSCO103
- Barnstead Sterilizer51
- Kavoklave48
- MDT Harvey Mediclaves128
- Midmark Ritter112
- Midmark ® Ritter547
- NAPCO27
- Pelton Crane867
- PRESTIGE 210050
- Ritter - Castle54
- Scican Statim259
- Spectroline26
- S.S. White24
- Tuttnauer ®1611
- 1730 Series317
- 2340 Series396
- 2540 Series419
- 3870 Series232
- EZ10 Autoclave Parts150
- EZ9 Autoclave Parts77
- How Tuttnauer Parts Work1
- Tuttnauer Diagnostic Tools13
- Tuttnauer Parts Installation1
- Tuttnauer Special Tools5
- Vernitron38
- Autoclave Repair Supplies30
- Autoclave Repair Special Tools6
- Bulk Sterilizers2277
- Autoclave Troubleshooting238
- AMSCO 3000 BASIC TROUBLESHOOTING1
- AMSCO 900 & 9012
- Castle Table Top Troubleshooting2
- CHEMICLAVE 5000 TROUBLESHOOTING0
- Delta Q Troubleshooting3
- Delta XL Troubleshooting1
- How To Test Heating Elements1
- Kavoklave2
- Midmark Troubleshooting106
- M9 & M11 ERROR CODES-NEWER UNITS44
- M9 & M11 ERROR CODES-OLDER UNITS37
- Error Code E0013
- Error Code E0021
- Error Code E0031
- Error Code E0041
- Error Code E0051
- Error Code E0061
- Error Code E0071
- Error Code E0082
- Error Code E0092
- Error Code E0101
- Error Code E0111
- Error Code E0121
- Error Code E0131
- Midmark Dip Switch Procedure1
- BLOWN FUSES1
- NO DISPLAY LIGHTS1
- LOW WATER LIGHT3
- NO POWER1
- FILL CYCLE MALFUNCTION3
- DOOR DOES NOT OPEN1
- NOT VENTING PROPERLY1
- TEMP STAYS BELOW 215F1
- INSTRUMENTS ARE WET1
- OPEN DOOR LIGHT NOT ON1
- ERROR CODE C0013
- ERROR CODE C0021
- ERROR CODE C0031
- Midmark M7 Troubleshooting Guide3
- Midmark M9 & M11 Troubleshooting17
- Midmark M9 & M11- Pressure Leaks5
- Testing Automatic Thermostats0
- NAPCO Troubleshooting7
- Pelton Crane Troubleshooting40
- Prestige 21002
- STATIM DETAILED TROUBLESHOOTING7
- Statim G4 Troubleshooting1
- STATIM TROUBLESHOOTING26
- Steam Trap Troubleshooting2
- tuttnauer temp0
- Tuttnauer Troubleshooting19
- VernitronTroubleshooting1
- Documents & Guides11
- Troubleshooting Guides4
- Dental Equipment Parts912
- Dental Chair Parts42
- Dental Handpieces & Parts6
- DENTAL ULTRASONIC SCALERS307
- DENTSPLY CAVITRON PARTS307
- BOBCAT® 25 KHz - G11528
- BOBCAT® Pro - G13032
- Cavitron Misc1
- DualSelect™ Disp Sys G11830
- G119 Parts Listing - Group A0
- JET Plus™ - G13228
- JET with SPS™ - G12043
- Plus™ Scaler - G13119
- Prophy-JET® Air Polish G12244
- Select SPS™ 30K - G12419
- Select™ Scaler 25K G12121
- SPS™ Surface Mount G98a10
- SPS™ UltraSon Scaler G11932
- DENTSPLY CAVITRON PARTS307
- Miscellaneous1
- Dental Compressor Parts65
- Dental Delivery Systems2
- Dental Film & X-Ray Processors194
- Dental Light Parts90
- Dental Vacuum Parts205
- MEDIVATORS6
- Videos and Animations0
- EXAM TABLES & CHAIRS727
- Exam Table/Chair Troubleshooting7
- HAMILTON0
- Midmark Ritter720
- 100 Series294
- 200 Series6
- 300 Series132
- 400 Series86
- 600 Series5
- EVOLUTION 75 Series197
- Evolution 7525
- Evolution 75 (-001); Serial#: AY2
- Evolution 75 (-002); Serial#: DF21
- Evolution 75 (-003); Serial#: DF20
- Evolution 75 (-004); Serial#: EM19
- Evolution 75 (-005); Serial#: EN19
- Evolution 75 (-006); Serial#: DZ17
- Evolution 75 (-007); Serial#: EY19
- Evolution 75 (-008); Serial#: EZ19
- Evolution 75 (-015); Serial#: KK18
- Evolution 75 (-018); Serial#: KL18
- Free Technical Support1
- Autopsy Saw Parts32
- Infant Incubators & Warmers136
- AIR SHIELDS - HILL-ROM - DRAGER5
- OHIO MEDICAL- OHMEDA - GE 131
- 1903
- 190A3
- Care Plus Series 1000/20007
- Care Plus Series 3000/40007
- General Care (GC)5
- Giraffe (Radiant Warmer)4
- Giraffe Exam Light1
- Giraffe Incubator19
- Giraffe Omnibed29
- Infant Care (IC)5
- Infant Warmer Systems (IWS) 20017
- Infant Warmer Systems (IWS) 30007
- Infant Warmer Systems (IWS) 30507
- Infant Warmer Systems (IWS) 31007
- Infant Warmer Systems (IWS) 31507
- Infant Warmer Systems (IWS) 33007
- Infant Warmer Systems (IWS) 43006
- Lab Equipment22
- Orthopedics & Physical Therapy268
- Patient Cables & Leadwires19
- Maintenance Guides6
- Operational Manuals9
- Maintenance Tips1
- Parts Installation Guides4
Important Links
- For Missions Only
- How To Repair Your Autoclave PC Control Board
- OCM OCR Exploded View -UPDATED
- Spore Test Failure
- Sterilizer FAQ
- Shipping Policy
- Return/Cancellation Policy
- Registered Trademarks
- Disclaimer
- Cleaning Statim Water Pump Filters
- Payment Methods
- International Customers
- How To Test Autoclave Heating Elements
- Testimonials
- Can't Find The Door Gasket (Seal) You Need?
- Used Autoclaves - What To Look For