Midmark M9 AIR VENT BELLOWS ASSEMBLY (BELLOWS STYLE)

Description

Part #RCB100-1224
Midmark Part #002-0375-00

AIR VENT BELLOWS ASSEMBLY

• 1/4" Compression Fittings Both Ends
• Bronze Bellows
• Actuates Within 5°F Of Saturated Steam
• See Notes Below For Serial Numbers This Part Fits

Fits: Reservoir Tubing

Model This Part Fits: Midmark M9 Autoclaves

Notes: CHECK SERIAL NUMBERS HERE:

• Fits M9-001 thru -019 with Serial # prefixes CZ, DA, DB, DX, DY, FD & OM

Now You Can Upgrade Your Midmark M9 From The Air Vent Bellows Assembly To the Newer Style, Longer Lasting Steam Trap Assembly With This Easy To Install Steam Trap Upgrade Kit Part #MIK078-1207

SERVICE TIP: AllClaveParts now offers two different Air Vent Bellows Assemblies - Part #RCB100-1224 and RCB089-1223. Heres the difference

Currently, the AllClaveParts RCB089-1223 and the Midmark are both Diaphragm Style assemblies. The Diaphragm is the older style and has only one convolution doing all the work.

The other is a Bellows Style assembly - the AllClaveParts RCB100-1224. This style assembly has several convolutions doing all of the work so it lasts much longer than the diaphragm style.

A. Removing The Midmark Bellows Assmebly

1. Remove back panel Click Here For Instructions
2. Disconnect tube (1) from tee (2)
3. Pull downward on bellows assembly (3) to remove bellows assembly from condensing tank (4)
4. Loosen and remove tubes (1 and 5) from bellows assembly (3)

NOTE: This Figure shows the old-style bellows. The procedure for the new-style is the same.

Installing the Midmark Bellows Assembly

1. Connect tubes (1 and 5) to bellows assembly (3)
2. Position bellows assembly (3) and insert tube (5) into tube hole of condensing tank (4)
3. Connect tube (1) to tee (2)
4. Install the back panel