Description

Part #MIK061-6924

DRAIN HOSE KIT

Includes

• (1) Hose Clamp Part #RPC286-7410
• (1) Drain Hose Part #RPH285-7426
• (2) Hose Clips Part #RPC283-7409
• (2) Pop Rivets Part #RPR284-7428

Model(s) This Part Fits: Midmark M9D Autoclave

Removing The Old Drain Hose

1. Unplug The Autoclave From The Outlet
2. Drain The Reservoir by Pulling the Drain Hose Away From The Bracked behind The Door and Guiding it Into a Sink or Bucket
3. Remove The Left Side Panel To Gain Access To Reservoir
4. Remove Clamp From Fitting On Bottom Of Reservoir Where Drain Hose Connects To The Reservoir
5. Pull Old Hose Off & Discard

Installing The New Midmark M9D Drain Hose

1. Feed New Drain Hose Through Opening In Face Panel
2. Slide Drain Hose Over Fitting on the Bottom Of The Reservoir Until Fully Seated
3. Install Clamp over Drain Hose & Fitting To Secure It In Place
4. Install New Drain Hose Clips If Needed On Face Plate Using Pop Rivets
5. Place Drain Hose in Face Drain Hose Clips To Secure It
6. Fill Reservoir and Inspect For Leaks
7. Replace Side Panel