(image for) OCR TEMPERATURE CONTROLLER (POTENTIOMETER)

OCR TEMPERATURE CONTROLLER (POTENTIOMETER)

Model: PCC112-090

$43.60

Description

Guaranteed High Quality Pelton Crane OCR Autoclave Repair Parts

Part #PCC112-090
Pelton Crane Part #004144

TEMPERATURE CONTROLLER (POTENTIOMETER)

  • Includes all parts as shown
  • Used with Solid State Controller
  • 20 K ohms
  • Instructions For Testing Your Temperature Controller Below

Fits: Control panel

Model This Part Fits: Pelton Crane OCR Autoclaves

Insallation Instructions Included

Look At The Back Of Your OCR, If it doesn't have the Solid State Controller Shown In The Picture Below, You Have A Hydraulic Unit & This Controller Will Not Work With Your Autoclave In It's Current State.

 

 

Pelton Crane Solid State Controller

 


The untis with out the Solid State Controller are early Pelton Crane models and were replaced when Solid State Circuity became practical, making the autoclaves much more efficient

If you do not have a Solid State Controller on your Autoclave, and you have a Problem with the Themistor or Temperature Controller, you will need to upgrade your autoclave with our Thermostat Conversion Kit. It includes all of the parts you will need

 

 

 

 

How To Test The Temperature Controller

 


This test consists of measuring the amount of resistance in the Temperature Controller. To do this, first, turn the autoclave off and unplug it from the wall

 

 

 

 

WARNING: CURRENT MUST NOT BE PRESENT WHEN MEASURING RESISTANCE.


Testing the Temperature Controller is a simple procedure.

 

 

  1. With the cabinet removed, look behind (on the inside) of the middle knob to find the controller
  2. Set your Volt Ohm Meter to 200k in the ohms section (indicated by the omega ω symbol)
  3. Place a probe on each of the two outside terminals (There are 3 terminals that stand off the controller as shown in the picture above) Reading should be 20k ohms
  4. Now place a probe on one of the outside terminals and one probe on the center terminal. Reading should be 10K.
  5. Rotate the knob counterclockwise as far as it will go. The meter should approach 0 on all configurations as above

If your readings are as above, the Temperature Controller is good. If they are outside of this range, the Temperature Controller is bad and needs to be replaced.

Your Done! (See, we told you it was simple!)
 

Don't Like To Solder Wire Connections?


The insulation around your wiring does deteriorate over time, and can cause electrical shorts and other problems

Get a Fresh Start By Replacing the Wiring & the Temperature Controller at the same time
No Soldering Needed

Order the OCR Wiring Harness Part #PCH187-106. Comes Complete With The New Temperature Controller all for only a few dollars more. It includes new wiring & the Temperature Controller with all of the connections pre-soldered and quick connects installed.

Fast Delivery

We usually ship the same day! All packages are shipped w/Delivery Confirmation.

100% Secure Payment

Your transaction is secure thanks to the PayPal payment system: SSL (Secure Socket Layer).

Shopper Award
(image for) AllClaveParts Payment Methods
allclaveparts.com widget logo