Statim 2000 WATER PUMP KIT (OLDER VERSION )

Description

Part #SCP050-6209
Statim Part #01-100568s (Invensys Pump - StatIM 2000)

WATER PUMP KIT

Specifications

• 120Volts, 60Hz.
• This Invensys brand pump will accommodate StatIM 2000 Sterilizers with PCB Software Rev. 6.3 or older only
• See Notes below

Includes:

• (7 pcs) Cable Tie (Part #RPT083-994)
• Water Filter (In-Line) (Part #SCF034-3822)
• Tubing (Part #RPT373-993)
• Metering Tube (290) (Part #SCT053-6215)
• Spring Clip
• Mounting hardware

Fits: Chassis
Model This Part Fits: Statim 2000 Autoclaves with PCB Software Rev. 6.4 or older only

Note: Even though the software version usually indicates which water pump is installed in the Statim Autoclaves, we have run into many instances where it is not accurate. Here is a surer way to make sure you get the pump you need

Be sure to look at the top of the water pump currently installed in your autoclave, and compare it with the pictures below.

If you have the Older Version with the Over Heat Thermostat as shown in the picture above, then this is the Water Pump You Need

But if you have the Newer Version without the Over Heat Thermostat as shown in the picture above, then click on the link below for your model for the Water Pump You Need:

• Statim 2000 Water Pump (Newer Version)Part #SCP051-6213

Click Here For Easy To Follow Instructions On Locating Your Software Revision Number

INVENSYS VERSION PUMP (Part #SCP050-6209) for Statim 2000 Autoclaves with Software R603 and older.

Statim 2000 autoclaves manufactured after March 2006 were supplied with the spring clip (grounding)on the water pumps to improve water conductivity circuitry (a Water Quality Sensor)

In early 2006, Statim introduced the Reservoir Cap & Filter Part #SCK059-6380

Effective June 2007, Statim stopped using the wire mesh filter (installed in the inlet and outlet fittings) and offered the In-Line Water Filter Part #SCF034-3822 to be installed between the reservoir and pump

Statim now recommends the use of the Reservoir Cap & Filter Part #SCK059-6380 along with the In-Line Water Filter on all units. For Statim 2000 Autoclaves with the original water pump, the wire mesh filters should be removed and the autoclave should be upgraded to the In-Line Water Filter Drain Kit with Pump Filter Part #SCK037-4013

Also available:

• Pump Kit (Part #SCP051-6213) Ulka Pump Sterilizers with PCB Software Rev. 7 and up only
• Drain Kit with Pump Filter (Part #SCK037-4013)
• Field Service Smart Kit (Part #SCK028-385)