Amsco Eagle 3000 Basic Troubleshooting For
Amsco Eagle 3000 Gravity & Vacumatic Sterilizers


No Power Check facility power source — turn on.
POWER switch OFF — turn ON
Unable To Select Cycle Chamber door(s) open — close and lock door(s). (Control will “beep” three times if door is open when cycle is selected.)
Chamber Temperature Does Not Rise To Correct Setting Chamber drain line or strainer plugged — clean line or strainer
Chamber Pressure & Temperature Drop During A Cycle Chamber drain line or strainer plugged — clean line or strainer
Pressure Too High, Temperature Too Low During Sterilization Phase Air trapped in chamber because of clogged strainer or drain — clean strainer inside chamber, flush and clean drain line and traps
Steam Escapes Around Door During Sterilization Phase Replace Worn Or Defective Door Gasket
Wrapped Items Are Wet After Completion Of Cycle, Or Excessive Vapor In Chamber When Door Is Opened Dry time too short for load type — increase setting
Water In Chamber Or Door Channel At End Of Cycle Drain plugged or clogged — clean drain.
Steam separator/strainer plugged — clean.
Drain line check valve defective — replace.
Jacket Pressure Does Not Rise To Required Level Steam supply hand valve not open — open valve.
Possible flood condition/steam supply solenoid valve closed
Steam supply less than 50 psig (3.52 kg/ dynamic — check supply pressure & increase if necessary
Cycle does not advance from prevacuum phase Door gasket worn or defective — replace
Chamber drain line or strainer plugged — clean line or strainer
Water supply hand valve not open — open valve
Water supply less than 30 psig (2.11 kg/ dynamic — check supply pressure and increase if necessary.
Steam supply insufficient — see 9 above; “Jacket pressure does not rise . . .”
HI-LO valve not set correctly — check that it is set on HI.

This product was added to our catalog on Tuesday 07 December, 2010.

Customer Reviews
Solution Graphics
Pay By Credit Or Debt Card
-Pay By Credit Card-
Proceed To Checkout And Enter Your Credit Card Information In Step 2

Pay By Credit Or Debit Card
To Order By Phone Call
Mon thru Fri 8:00am To 4:30 pm Central Time


Don't Take Our Word For It.....

Customer Reviews - Real Help With Your Autoclave Repair When You Need It

"My Statim 2000 stopped working.

Benco dental came down and said the thermal fuse and computer board was bad

Real Problems Solved By Dr Gorenburg With AllClaveParts help

Wally, thank you and your company for providing great customer service and all the help I needed to fix my autoclave.

Dr Haruki & Son

My tech told me my STATIM 2000 repair could either be about $350 (if it was only the thermal fuse) or up to $1500 if it was another problem.

Craig Haruki DDS
Lihue, HI

Dr Whitehouse Loves
"It was a pleasure working with Wally who saved me thousands over what I would have had to pay when the Patterson tech......"

Dr Joseph Whitehouse
Castro Valley, CA
Create A Smile

Dr Steve Says Midmark Told Him To Throw It Away, But AllClaveParts Showed Him How To Fix It Well, that same autoclave is once again working like a champ thanks to

Steve Douglas, DDS
Indianapolis, IN

Parse Time: 0.259 - Number of Queries: 186 - Query Time: 0.120268399765

Check Out Our Specials

A Best Seller
Click Here To Check Out Everything On Sale