Midmark M9 DOOR SWITCH ASSEMBLY (For Older Models)


Add to Cart:

  • Description
  • Info & Guide
  • Specs
  • Reviews
Midmark M9 High Quality Guaranteed Replacement Parts

Part #MIS039-1211
Midmark Part #002-0362-00

  • See Notes below for Serial Numbers this part fits
  • Includes door switch and 2 roll pins (3/32" diameter x 1/2" long)

Fits: Switch Weldment
Models This Part Fits: Midmark M9 Autoclaves

Notes: Notes: This part fits M9 Serial #'s -001 thru -019 with prefixes CZ, DA, DB, DX, DY, FK, FL, LA & OM; M9D Serial #'s -001 thru -019 with prefixes FF & FG; M11 Serial #'s -001 thru -019 with prefixes ES, ET, FP, FR, GB & NP; M11D Serial #'s -001 & -019 with prefixes GC & GD

Door Switch Removal & Installation Instructions
M9 Door Switch Removal

Units prior to serial number CZ1110/OM1000 have a different switch weldment. Since this procedure tampers with the pressure vessel integrity, it should not be attempted until a Midmark service representative has been contacted.

  1. Open sterilizer door
  2. Remove right hand side panel (See Instructions Here)
  3. Disconnect wire harness (1) from connector (2)
  4. Using 3/32 in. punch, remove two roll pins (3) from door switch bracket (4)
  5. Remove door switch (5) from door switch bracket (4)
M9 Door Switch Installation

  1. Position door switch (5) in door switch bracket (4).
  2. Using 3/32 in. punch, install two roll pins (3) in door switch bracket (4)
  3. Connect wire harness (1) to connector (2)
  4. Install right hand side panel (See Instructions Here)
  5. Close sterilizer door
"Midmark M9 Autoclave Repair Made Simple™"

There are currently no any reviews about this product.

Customer Reviews
Solution Graphics
Pay By Credit Or Debt Card
-Pay By Credit Card-
Proceed To Checkout And Enter Your Credit Card Information In Step 2

Pay By Credit Or Debit Card
To Order By Phone Call
Mon thru Fri 8:00am To 4:30 pm Central Time


Don't Take Our Word For It.....

Customer Reviews

AllClaveParts.com - Real Help With Your Autoclave Repair When You Need It

"My Statim 2000 stopped working.

Benco dental came down and said the thermal fuse and computer board was bad

Real Problems Solved By Dr Gorenburg With AllClaveParts help

Wally, thank you and your company for providing great customer service and all the help I needed to fix my autoclave.
Clearview Medical.com

Dr Haruki & Son

My tech told me my STATIM 2000 repair could either be about $350 (if it was only the thermal fuse) or up to $1500 if it was another problem.

Craig Haruki DDS
Lihue, HI

Dr Whitehouse Loves AllClaveParts.com
"It was a pleasure working with Wally who saved me thousands over what I would have had to pay when the Patterson tech......"

Dr Joseph Whitehouse
Castro Valley, CA
Create A Smile

Dr Steve Says Midmark Told Him To Throw It Away, But AllClaveParts Showed Him How To Fix It Well, that same autoclave is once again working like a champ thanks to allclaveparts.com.

Steve Douglas, DDS
Indianapolis, IN

Parse Time: 0.273 - Number of Queries: 226 - Query Time: 0.128488612457

Check Out Our Specials

A Best Seller
Click Here To Check Out Everything On Sale