GLS10 Heating Element Troubleshooting




How To Test The GLS10 Dual Heating Element


This test consists of measuring the amount of resistance in the element. To do this, first, turn the autoclave off and unplug it from the wall

WARNING: CURRENT MUST NOT BE PRESENT WHEN MEASURING RESISTANCE.

Set your volt/ohm meter on 200 ohms (200 NOT 200k). The ohms range is located within the Omega (Ω )(look for this symbol) section of your meter. It is also the area with "k" ' ranges (ie: 2000k,. 200k, 20K and then 2000, 200).

The lowest setting on your meter is always the most accurate

This heating element has 3 wire leads and the spot where each wire lead orginates from is stamped on the heating element as follows:
  1. 1300W
  2. COMM
  3. 100W


As you unplug each lead from the board, make a note of where you removed it from to simplify reconnecting when you are finished with this test

Place a probe from your meter into the plug on the center wire, marked "COMM" and place the second probe from your meter into the plug marked 1300W and write down the reading on your meter.

Now, place a probe into the center plug marked COMM and the other probe into the plug marked 100W and again record your readings

Simply compare your readings to those corresponding to those in the table below

For the heating elements to be good, they must fall within the resistance range in this table. If your readings for either element are outside of the ranges below, then it is defective and the heating element needs to be replaced.
Model Volts Watts Amps Resistance Resistance Range
MDT Ritter Castle GLS10 Dual Heating Element 120v 1350 Watts 11.250 amps ~10.0 Ohms 9.00 ↔ 11.00 ohms
MDT Ritter Castle GLS10 Dual Heating Element 120v 100Watts 00.833 amps ~144 Ohms 129.6 ↔ 158.4 ohms


This product was added to our catalog on Sunday 21 October, 2012.



Customer Reviews
Solution Graphics
Pay By Credit Or Debt Card
-Pay By Credit Card-
Proceed To Checkout And Enter Your Credit Card Information In Step 2

Pay By Credit Or Debit Card
To Order By Phone Call
636-390-2792
Mon thru Fri 8:00am To 4:30 pm Central Time

Testimonials

Don't Take Our Word For It.....


Customer Reviews


AllClaveParts.com - Real Help With Your Autoclave Repair When You Need It

"My Statim 2000 stopped working.

Benco dental came down and said the thermal fuse and computer board was bad

Real Problems Solved By Dr Gorenburg With AllClaveParts help

Wally, thank you and your company for providing great customer service and all the help I needed to fix my autoclave.
Clearview Medical.com

Dr Haruki & Son

My tech told me my STATIM 2000 repair could either be about $350 (if it was only the thermal fuse) or up to $1500 if it was another problem.

Craig Haruki DDS
Lihue, HI


Dr Whitehouse Loves AllClaveParts.com
"It was a pleasure working with Wally who saved me thousands over what I would have had to pay when the Patterson tech......"

Dr Joseph Whitehouse
Castro Valley, CA
Create A Smile


Dr Steve Says Midmark Told Him To Throw It Away, But AllClaveParts Showed Him How To Fix It Well, that same autoclave is once again working like a champ thanks to allclaveparts.com.

Steve Douglas, DDS
Indianapolis, IN
stevedouglasddspc.com


Parse Time: 0.374 - Number of Queries: 194 - Query Time: 0.214339493423
Content

Check Out Our Specials


A Best Seller
Click Here To Check Out Everything On Sale