Testing The Prestige 2100 Heating Element

Testing The Heating Element Consists Of Simply Measuring The Resistance of the Element. To perform this test, you will need an Ohm Meter, nothing fancy or expensive. You can buy a cheap (but good) meter from Lowes, Home Depot or even Walmart for around $20.00 (a digital readout is easiest to work with)


How To Test The Prestige 2100 Heating Element


To gain access to the heating element terminals for testing, you will need to remove the cover on the bottom of the unit. Simply folow the instructions below


  1. Remove the 3 screws as shown in the picture above
  2. Carefully, pull the plate down far enough to give you access to the inside - Do not disconnect the wires from the board connectd to the plate
  3. Place the probes from your ohm meter to the Heating Element Terminals (not the wires) shown in the picture below
  4. The Heating Element For The 120v Model is Rated at 12 ohms. Your reading should be within 10% (Between 10.8 ohms & 13.2 ohms) For The Element To Be Good
  5. The Heating Element For The 230v Model is Rated at 42 ohms. Your reading should be within 10% (Between 37.8 ohms & 46.2 ohms)

The Heating Element on The Prestige 2100 is built into the body. And cannot be replaced. So, if it is defective, you will need to purchase the Prestige 2100 Body Kit. Click Here for the 120V Model (Part Number KVK016-4071) or Click Here for the 230V Model (Part Number KVK015-4070)


This product was added to our catalog on Friday 02 November, 2012.



Customer Reviews
Solution Graphics
Pay By Credit Or Debt Card
-Pay By Credit Card-
Proceed To Checkout And Enter Your Credit Card Information In Step 2

Pay By Credit Or Debit Card
To Order By Phone Call
636-390-2792
Mon thru Fri 8:00am To 4:30 pm Central Time

Testimonials

Don't Take Our Word For It.....


Customer Reviews


AllClaveParts.com - Real Help With Your Autoclave Repair When You Need It

"My Statim 2000 stopped working.

Benco dental came down and said the thermal fuse and computer board was bad

Real Problems Solved By Dr Gorenburg With AllClaveParts help

Wally, thank you and your company for providing great customer service and all the help I needed to fix my autoclave.
Clearview Medical.com

Dr Haruki & Son

My tech told me my STATIM 2000 repair could either be about $350 (if it was only the thermal fuse) or up to $1500 if it was another problem.

Craig Haruki DDS
Lihue, HI


Dr Whitehouse Loves AllClaveParts.com
"It was a pleasure working with Wally who saved me thousands over what I would have had to pay when the Patterson tech......"

Dr Joseph Whitehouse
Castro Valley, CA
Create A Smile


Dr Steve Says Midmark Told Him To Throw It Away, But AllClaveParts Showed Him How To Fix It Well, that same autoclave is once again working like a champ thanks to allclaveparts.com.

Steve Douglas, DDS
Indianapolis, IN
stevedouglasddspc.com


Parse Time: 0.523 - Number of Queries: 185 - Query Time: 0.301804358063
Content

Check Out Our Specials


A Best Seller
Click Here To Check Out Everything On Sale