Getting Inside The Statim 2000



In order to troubleshoot and complete most repairs, you will need to remove the cover off of the machine to gain access to the interior components



How To Remove The Cover On The Statim 2000 Autoclave


Removing the cover on the Statim Autoclave is easy, once you follow these simple steps

Warning Unplug the Autoclave From the Outlet Before Proceeding

  1. Remove the Cassette from the Cassette Bay and set it aside
  2. Remove the Lid from the Water Reservoir and set it aside
  3. Remove the six crews holding the cover to the base of the autoclave (2 on each side and 2 from the rear)
  4. Slide The unit to where the control panel on the front of the autoclave is hanging off the counter as shown in the picture below
  5. Lift up on the rear of the cover and push it slightly forward
  6. Rotate the cover off while watching the 2 ribbon cables running from the front of the cover to the PC board - Be careful not to stress the connections - and to the side of the autoclave and stand it on it's side - close to the autoclave so the ribbon cables are not pulled tight
Removing the Statim 2000 cover is easy....just follow these directions


TIP: Statim 2000 Test Cable

Many troubleshooting procedures require you to run the machine with the cover off. With the cover laying on it's side, this can turn a simple process into a complicated, and potentially dangerous, procedure.

But, by using the Statim 2000 Extension Test Cable Part #SCT026-388, you can lay the cover flat next to the autoclave, and operate it normally.

With the cover laying flat, it eliminates the possibility of the cover falling and breaking the pins off of the board - damaging it and subjecting you to costly replacement

We always use the extension test cable, and those who have purchased it tell us it is the most useful tool they have!


Putting The cover Back On The Statim Autoclave

To put it all back together again, just follow the steps above in reverse order



This product was added to our catalog on Tuesday 24 February, 2015.



Customer Reviews
Solution Graphics
Pay By Credit Or Debt Card
-Pay By Credit Card-
Proceed To Checkout And Enter Your Credit Card Information In Step 2

Pay By Credit Or Debit Card
To Order By Phone Call
636-390-2792
Mon thru Fri 8:00am To 4:30 pm Central Time

Testimonials

Don't Take Our Word For It.....


Customer Reviews


AllClaveParts.com - Real Help With Your Autoclave Repair When You Need It

"My Statim 2000 stopped working.

Benco dental came down and said the thermal fuse and computer board was bad

Real Problems Solved By Dr Gorenburg With AllClaveParts help

Wally, thank you and your company for providing great customer service and all the help I needed to fix my autoclave.
Clearview Medical.com

Dr Haruki & Son

My tech told me my STATIM 2000 repair could either be about $350 (if it was only the thermal fuse) or up to $1500 if it was another problem.

Craig Haruki DDS
Lihue, HI


Dr Whitehouse Loves AllClaveParts.com
"It was a pleasure working with Wally who saved me thousands over what I would have had to pay when the Patterson tech......"

Dr Joseph Whitehouse
Castro Valley, CA
Create A Smile


Dr Steve Says Midmark Told Him To Throw It Away, But AllClaveParts Showed Him How To Fix It Well, that same autoclave is once again working like a champ thanks to allclaveparts.com.

Steve Douglas, DDS
Indianapolis, IN
stevedouglasddspc.com


Parse Time: 0.376 - Number of Queries: 193 - Query Time: 0.234345142593
Content

Check Out Our Specials


A Best Seller
Click Here To Check Out Everything On Sale