
Now Available For Immediate Delivery |
Part #SCP050-6211
Statim Part #01-101761s (Invensys Pump - StatIM 5000)
WATER PUMP KIT
- 120Volts, 60Hz.
- This Invensys brand pump will accommodate StatIM 5000 Sterilizers with PCB Software Rev. 6.3 or older only
- See Notes below
Fits: Chassis
Model This Part Fits: Statim 5000 Series with PCB Software Rev. 6.4 or older only
Make Sure You Order The Right Water Pump for Your Statim Autoclave
Even though the software version usually indicates which water pump is installed in the Statim Autoclaves, we have run into many instances where it is not accurate.
Be sure to look at the top of the water pump currently installed in your autoclave, and compare it with the pictures below.
If you have the older version with the Over Heat Thermostat as shown in the picture above, then this is the Water Pump You Need
But, if you have the newer version without the Over Heat Thermostat as shown in the picture above, then click on the link below for the Water Pump You Need:
Click Here For Easy To Follow Instructions On Locating Your Software Revision Number
Notes: Includes:
Also available:
- Pump Kit (Part #SCP051-6211) Ulka Pump Sterilizers with PCB Software Rev. 7 and up only
- Drain Kit with Pump Filter (Part #SCK037)
- Field Service Smart Kit (Part #SCK028-523)