(Illustration Below)
Section 2 - Validator Plus Theory Of Operation

The Validator Plus is a fully automatic autoclave which allows an operator to selecrt one of the four preset functions (WRAPPED, UNWRAPPED, PACKS & LIQUIDS) and one user-programmable function (SPECIAL) for sterilization or disinfection. The microprocessor automatically selects the cycle time, temperature and pressure for the selected program.

When the operator depresses the CLEAR/START button (A), the unit will display the selected mode's parameters for four seconds and then fill the chamber with distilled water from the reservoir. When the filling period is complete, automatic activiation of the heating elements builds temperature and pressure for the desired cycle.

At the point that saturated steam conditions are met, the unit will continuously build temperature and pressure to the minimum values of the mode selected.

WRAPPED/UNWRAPPED: 134 ° C and 216 kPa
PACKS/LIQUIDS: 121 ° C and 115 kPa
SPECIAL: per the operators preference. The range of values that can be set for SPECIAL mode are 101 ° C - 135 ° C for temperature & 1-90 minutes for the time. If the temperature is set below 106 ° C for the SPECIAL mode, the drying cycle will be disabled.

Once the minimum parameters for the selected mode have been met, the countdown timer begins.

The Validator Plus provides some of its status information through audible signals. A single beep is provided each time a self-diagnostic check is requested or the selection of a programmed cycle.

Five continuous beeps indicate the beginning of the drying cycle and five more beeps indicate the completion of the cycle.

Continuous beeps for one minute indicate an operatational error. (Beeper can be silenced during an operational error by depressing the CLEAR/START button. Be sure to record the display status before depressing the button as the display may also be cleared at this time).

There are no products to list in this category.

Customer Reviews
Solution Graphics
Pay By Credit Or Debt Card
-Pay By Credit Card-
Proceed To Checkout And Enter Your Credit Card Information In Step 2

Pay By Credit Or Debit Card
To Order By Phone Call
Mon thru Fri 8:00am To 4:30 pm Central Time


Don't Take Our Word For It.....

Customer Reviews - Real Help With Your Autoclave Repair When You Need It

"My Statim 2000 stopped working.

Benco dental came down and said the thermal fuse and computer board was bad

Real Problems Solved By Dr Gorenburg With AllClaveParts help

Wally, thank you and your company for providing great customer service and all the help I needed to fix my autoclave.

Dr Haruki & Son

My tech told me my STATIM 2000 repair could either be about $350 (if it was only the thermal fuse) or up to $1500 if it was another problem.

Craig Haruki DDS
Lihue, HI

Dr Whitehouse Loves
"It was a pleasure working with Wally who saved me thousands over what I would have had to pay when the Patterson tech......"

Dr Joseph Whitehouse
Castro Valley, CA
Create A Smile

Dr Steve Says Midmark Told Him To Throw It Away, But AllClaveParts Showed Him How To Fix It Well, that same autoclave is once again working like a champ thanks to

Steve Douglas, DDS
Indianapolis, IN

Specials  [more]

$1,199.97  $988.36
Save: $211.61 off
Parse Time: 0.288 - Number of Queries: 189 - Query Time: 0.140846628983

Check Out Our Specials

A Best Seller
Click Here To Check Out Everything On Sale